If you have no captions in the area to be removed, just create one long caption in that area, and then Ctrl-drag the end of that caption left as discussed. And even if you drag past the caption to the left, all that happens is the caption you are dragging is deleted, and the captions to the right ripple left - by that small amount. Except that it only changes up to the beginning of that caption. This works the same dragging to the left. If you had Ctrl down, the caption extends to the release point, and the captions to the right ripple adjust. When you release the click, if you did NOT have Ctrl pressed down, the caption stops at the next caption. Once you get to another caption, the caption stops adjusting, but the little line continues. (Cannot get a screenshot!) When you press Ctrl down, the red bracket arrow turns to white. When you drag the end of a caption (with or without Ctrl), you see a little line in the timecode ruler area, and you see the caption adjusting as you drag. When you hover over the end of the caption, you see the red "bracket and arrow" drag symbol. If you press Ctrl after you click, it operates as if Ctrl was not down. (That caption gets grey.) You must hold the Ctrl (Cmd) key down before clicking on the end of the caption to drag. My method: Select the caption stream in the timeline. But reducing has a different set of problems I'll discuss below. And when I tested (for the first time) REDUCING the caption stream, it also works. I did not know that!ĮXTENDING the caption stream, which is what was discussed in this thread, is working in 2020.2.0. If you drag it to the left, it ignores the CTI, so you can place it as you wish. ![]() I think the chat person is wrong about what the history panel calls "Ripple Update Caption." The snap to CTI is interesting: if you drag the end of a caption to the right (make it longer), and you get close to the CTI, the end snaps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |